MIK-PH7001 Flat pH sensor for flue gas desulfurization

MIK-7001 Flat pH electrode can be used for pH measurement of flue gas desulfurization (FGD), or other harsh environment, such as whitewash, seriflux, etc.


Zero potential point: 7 ± 0.5 pH

Conversion coefficient: > 96%

Installation size:  3/4NPT

Pressure: 1 ~ 6 Bar at 25 ℃

Temperature: 0 ~ 60℃ for general cables

  • Specification

  Product    Flat pH sensor
  Model   MIK-PH7001
  Measurement range   0-14 pH
  Zero potential point   7 ± 0.5 pH
  Slope   > 96%
  Internal impedance   150-250 MΩ(25℃)
  Practical response time   < 1 min
  Installation size   Upper and Lower 3/4NPT Pipe Thread
  NTC   NTC10K/Pt100/Pt1000
  Heat resistance   5-80℃ for general cables
  Pressure resistance  0.2MPa
  Connection   Low-noise cable


  • Introduction

Supmea pH sensor for flue gas

  • Application

Industrial wastewater engineering
Process measurements, electroplating plants, paper industry, drinks industry
Wastewater containing oil
Suspensions, varnishes, media containing solid particles
Two-chamber system for when electrode poisons are present
Media containing fluorides (hydrofluoric acid) up to 1000 mg/l HF

Need more information?

Contact us for more details about our boilers,solutions and services